Tunnel的具体配置

sddfrt453

GRE Tunnel The second procedure is to set up the GRE tunnel and route IPX through it to the Cisco 1600. This procedure involves creating the tunnel inte***ce on both routers. The Ethernet 0 of the Cisco 1600 and the Ethernet 1/1 of the Cisco 7206 are the endpoints of the tunnel. It will be a *** IP GRE tunnel.1. Configure the tunnel inte***ce of the Cisco 7206:central7206#conf tEnter configuration commands, one per line. End with CNTL/Z.central7206(config)#inte***ce tunnel 0central7206(config-if)#tunnel source e 1/1central7206(config-if)#tunnel destination 192.168.113.2central7206(config-if)#%LINEPROTO-5-UPDOWN: Line protocol on Inte***ce Tunnel0, changed state to up2. Configure the tunnel inte***ce of the Cisco 1600:home1600#conf tEnter configuration commands, one per line. End with CNTL/Z.home1600(config)#inte***ce tunnel 0home1600(config-if)#tunnel source Ethernet 0home1600(config-if)#tunnel destination 192.168.114.2home1600(config-if)#%LINEPROTO-5-UPDOWN: Line protocol on Inte***ce Tunnel0, changed state to upIPX through GRE1. Enable IPX routing on the Cisco 1600:home1600(config)#ipx routinghome1600(config)ipx router riphome1600(config-ipx-router)#network 1681130home1600(config-ipx-router)#network 16811312. Turn on the IPX networks on its Ethernet and tunnel inte***ces:home1600(config)#inte***ce ethernet 0home1600(config-if)#ipx network 1681130home1600(config-if)#inte***ce tunnel 0home1600(config-if)#ipx network 16811313. Turn on IPX network 1681131 on the tunnel inte***ce of the Cisco 7206:central7206(config)#inte***ce tunnel 0central7206(config-if)#ipx network 16811314. Turn on IPX Routing Information Protocol (RIP) on the Cisco 7206, and enable route redistribution:central7206(config)#ipx router ripcentral7206(config-ipx-route)#redistribute eigrp 2central7206(config-ipx-route)#network 1681131central7206(config-ipx-route)#ipx router eigrp 2central7206(config-ipx-route)#redistribute rip